Using your Westinghouse TV without the remote control can be cumbersome. So, if your remote control suddenly picks a fault or stops working, your best bet is to fix it as soon as possible.
But before you take your Westinghouse TV remote controller for repairs, try to figure out what the problem is. The problem might be a simple one that you can fix on your own.
In this article, you’d learn the most common reasons why your Westinghouse TV remote isn’t working, and what you can do to fix the problem on your own.
Westinghouse TV Remote Control Not Working: Likely Causes
Low or dead battery: If your remote suddenly stops working, the problem could be with the batteries. You should replace the old ones with new batteries to see if the device could start working again.
Dirt or dust underneath the buttons: If the remote is used for a period of time, dirt and dust can find themselves stuck in the buttons of the remote. This could lead to some buttons not working properly or using force to press buttons till they work.
Internal technical malfunctions: Your remote could stop working if something is broken inside. This can only happen when it experiences a crash on a hard surface like the floor.
We have looked at the possible causes why your TV remote might not work, while the first two causes can easily be fixed, fixing the third cause might require the help of a technician, except you are a tech person yourself.
How to Fix Your Faulty Westinghouse TV Remote Controller
Fix 1: Reset the remote
To do this, follow the steps below.
- Switch off your TV and unplug it from the socket.
- Remove the batteries from the remote.
- Hold down the power button on the remote control for a minute to drain power from the remote and cause it to reset.
- Once this is done, fix the batteries back into their position in the remote.
- Plug your TV set and switch it on to test it.
If this does not give the desired result, you can redo this over again or you can try the next fix.
Fix 2: Remove dirt or dust
To do this, follow the steps below.
- Start by removing the batteries from your TV remote and switching off your TV set.
- Pick your remote and hold the power button for about a few seconds.
- Then begin to press all the buttons on your remote one by one for more than a minute.
- Do this over again till you are satisfied that your buttons are free from accumulated dirt and dust.
- Fix your batteries back into their positions and switch on your TV to test it.
If this does not work, you can go over it again a few times and ensure that all your buttons are not stuck.
If the two methods above do not work, then you would need to consider replacing your batteries with a new and better set. It is very likely that the old batteries have been overused and in need of replacements.
To sum everything up, your Westinghouse TV remote can easily be fixed if you through the processes above by either resetting the remote, changing your batteries, or removing the dirt from stuck buttons. What if you have tried everything here and it does not still work? Then, I will advise that you contact your customer care service to repair or purchase a new Westinghouse TV remote control.
